| TSP Lab | The Ethernet monitoring card handler module | Sga-PacketDistributor |
|---|
| Event code | Event | Description |
|---|---|---|
| 19 | NTP error | No answer from NTP server |
| 20 | Network error | No network connection |
| 21 | Too high clock adjustment | To much difference in time between the NTP server and the monitor unit (no clock adjustment done) |
| 2010 | No traffic in the last period | No traffic seen on the given card in the last period. The time period can be configured by the TrafficSamplingInterval entry in the card section. The linkID refers to a single card stated in the card section by the InputLinkID entry |
| 2011 | All monitors connected | All of the monitors are connected (again) to the poller |
| 2012 | At least 1 monitor not OK | At least one monitor disconnected from the poller |
| 2013 | 1GB signal detected | Traffic detected (again) on the 1GB interface |
| 2014 | 1GB signal lost | Signal lost on the 1GB interface |
| 2015 | 10GB signal detected | Traffic detected (again) on the 10GB interface |
| 2016 | 10GB signal lost | Signal lost on the 10GB interface |
| 2017 | Bad frames | Undecodable frames detected on the stream |
| 2018 | Lost frames | Messages lost either on the input, or the output interface |
| 2020 | Unknown event | Unknown event |
| 2021 | Sga-ClockCard configuration error | Wrong configuration detected, please check the correct settings |
| 2022 | Sga-ClockCard communication lost | Communication lost towards the Sga-ClockCard, please check the cabling |
| 2023 | Sga-ClockCard no link detected | No network connection towards the Sga-ClockCard, please check the cabling |
| 2024 | Sga-ClockCard ARP timeout | No ARP answer received |
| 2025 | Sga-ClockCard NTP timeout | No NTP answer received |
| 2026 | Sga-ClockCard synchronization OK | NTP sync succeeded |
| 2027 | Sga-ClockCard synchronization failed | NTP sync failed |
| 2028 | Sga-ClockCard GPS OK | GPS sync succeeded |
| 2029 | Sga-ClockCard GPS failed | GPS sync failed |
| Counter | Data | Description |
|---|---|---|
| 9003 | No of recieved bytes | Number of the received bytes in the last period. The time period can be adjusted with the StatisticsReportPeriod entry |
| 9004 | No of bad frames | Number of the bad frames in the last period. The time period can be adjusted with the StatisticsReportPeriod entry |
| 9005 | No of lost frames | Number of the lostframes in the last period. The time period can be adjusted with the StatisticsReportPeriod entry |